P
AGE 12
SWOOP Manual & Parts List - PN 234656 - Rev C (applicable to previous versions of this model) - Printed in USA 12/10/07
TROUBLE SHOOTING GUIDE
PROBLEM: Motor will not run.
POSSIBLE CAUSE POSSIBLE SOLUTION
1) Defective switch. 1) Check switch, replace if defective.
2) Defective power cord or wiring. 2) Check and replace if defective.
3) Defective motor. 3) Have motor checked by an authorized service center.
4) Blown fuse or tripped circuit 4) Replace fuse or reset circuit breaker. If this does
breaker at wall panel. not correct the problem, have the machine
checked by an authorized service center.
5) Power cord not plugged in 5) Plug in power cord properly or replace
properly or damaged. power cord if damaged.
6) Motor hums but does not turn. 6) Loss of phase, check breakers/fuses.
PROBLEM: Machine bogs down and runs slow.
POSSIBLE CAUSE POSSIBLE SOLUTION
1) Circuit may be overloaded with 1) Plug floor machine into a dedicated power outlet.
more than one appliance. If the problem still exists there could be a short. Have
the machine checked by an authorized service center.
2) Low line voltage in building. 2) If wiring is old in the building have voltage
checked by the power company.
3) Running hot and overloading. 3) Check incoming voltage. Ensure 480V is maintained
especially when using a generator.
PROBLEM: Noisy machine or vibration.
POSSIBLE CAUSE POSSIBLE SOLUTION
1) Defective motor or loose parts. 1) Contact the manufacturer or authorized service center.
2) Attachment is not level or 2) Level attachment and make sure all fasteners are secure.
securely attached.
Address: 777 South Street,P.O. Box 2310, Newburgh, New York 12550-0606
TEL: 877.356.6703 / 845.565.6623 / FAX: 845.565.8894
Internet Address: www.onfloor.com / techsupport@onfloor.com
®
To Previous Page
Loading...
Need help?
General