EasyManua.ls Logo

onga Pool Pumps - User Manual

onga Pool Pumps
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER’S MANUAL
An earth leakage or residual current protection device must be
fitted to all installations.
Should you the installer or owner be unfamiliar with the correct
installation or operation of this type of equipment you should contact
the distributor/manufacturer for the correct advice before proceeding
with the installation or operation of the product.
Pantera Pool Pumps

Table of Contents

Questions and Answers

  • W
    William LynchJul 26, 2025
    What to do if my Onga Swimming Pool Pump does not run?
    • H
      haydencarrJul 26, 2025
      If your Onga Swimming Pool Pump does not run, first, check the power outlet using another electrical appliance that is known to work. Then, check the fuse and replace it if necessary. If those aren't the issue, the automatic thermal overload may have tripped to protect the motor. In that case, switch the power off and allow the motor to cool before switching it back on. Ensure adequate ventilation around the pump and motor. Also, make sure the pump isn't jammed with debris and that the motor shaft spins freely. Finally, the motor may be burnt out due to a voltage spike or flooded by water, in which case it may need replacing.
  • J
    Jesus SalinasAug 11, 2025
    Why is my Onga Swimming Pool Pump operating with reduced or no flow?
    • E
      Erin FinleyAug 12, 2025
      If your Onga Swimming Pool Pump operates with reduced or no flow, first, check the plumbing to ensure the valves are in the correct position for filtering, including any valves on the suction or discharge of the pump. Also, the filter may be dirty, so clean it. Finally, check for air ingress to the system by re-priming the pump and ensuring that there are no air leaks in the suction piping or fittings. Make sure the hair & lint pot lid is closed and airtight and check for leaks beneath the pump and casing.

Summary

Pantera Pool Pumps

Safety

Technical Data

Provides specifications including inlet, outlet, pressure, temperature, IP rating, and electrical ratings.

Installation

Operation

Priming Pump

Details the process for filling the pump with water before starting operation.

Start-up Procedure

Outlines the steps to follow for safely starting the pump after priming.

Service & Maintenance

Routine Maintenance

Instructions for inspecting and cleaning the leaf basket and checking for leaks.

Removal of Pump for Servicing

Parts Identification

Lists and identifies all components of the pump with corresponding part numbers.

Parts Diagram

Troubleshooting

onga Pool Pumps Specifications

General IconGeneral
Brandonga
ModelPool Pumps
CategorySwimming Pool Pump
LanguageEnglish

Related product manuals