54
REMOTE OVERVIEW
OPERATIONS
1. Open back cover and put 2 Nos. AAA size alkaline batteries.
2. The remote signal can be reached upto six metres from the indoor unit.
3. When the button is pressed on remote, indoor unit will “beep” once, indicating
the receipt of signal. If no “beep” sound is heard, press the button once again.
4. Remove batteries if remote control has not been used for long time.
5. *Heat mode & Money Saved is not available with all models.
Operating Your Air Conditioner:
Your Split Air Conditioner can be conveniently operated using the intelligent cordless
remote control.
1. Switch on the MCB.
Press Standby button on remote handset to switch ON the AC.
All icons will glow once.
Your AC switches on with parameters that were set before power was switched
off. The unit receives the signal with "BEEP" tone and your AC starts operation.
Time Delay: To protect the compressor, a time delay is incorporated in the circuit.
The Time Delay ensures that the compressor switches ON only after a delay of about 3
minutes.
2. Press the “MODE” Button for Turbo, Auto, Cool, Dry, Eco or Fan Mode selection.
3. Press the "FAN” Button to set the Fan Speed. Each press changes the fan speed
from Low-Med.- High-Auto Fan speed. The selected fan setting symbol can be
seen on the LCD.
4. The Set Temp. is displayed on LCD, Press button ” + “ to increase and “ “ to the
decrease the temperature.
5. To switch off the AC, press the Standby Button.
Setting the Desired Room Temp.:
You can set the temp. at which you would like your room to be.
O
Press " " button to increase the set temp. On every press, the temp. increases by 1 C.
O
Press " " button to decrease the set temp. On every press, the temp. decreases by 1 C
The two digit display shows the set temp. on LCD.
O
The setting temp. range is from 16- 31 C.
-
+
-
Your split AC operates in one of six modes, TURBO-AUTO-COOL-DRY-ECO-FAN.
The modes button cyclically chooses between these operating modes.
*Cooling capacity measured at High speed, as per IS 1391:1992 Part 2
Standby
Mode
Timer
Display
Sleep
iCOOL
On /Off
Temperature Up
Fan Speed Adjustment
Operation Mode
Ceiling Fan Speed
IR Signal Window
Operation Display
Temperature Down
My Favorite Mode
iCOOL Mode
Sleep Mode
Swing Auto / Manual
IDU Display On/Off
On & Off Timer
To Next Page
Loading...
Need help?
General
