Maintenance
Maintenance
Plug out the power cord
from the outlet first.
1
Clean the filter in the inlet valve. Clean the filter when water supply into the tub is bad or the
inlet valve is clogged with impurity.
Pull out the filter from the
inlet valve with fingers.
2
Use a tooth brush to get rid
of filth and then insert the
filter back in position.
3
-13-
Clean the waste thread collected in the Magic Lint filter.
Clean the brush to get rid off residues and lints accumulated over the bristles.
Note :
1. Bristle distortion might be there in the brush a . This will be resumed
before next wash.
fter completion of wash cycle
2. If bristles are coming out of brush call Onida service person & replace with the new brush.
Push the upper
Push the upper
part of the filter
part of the Brush
and pull in.
Open the cover
as shown in
the figure.
Clean the filter.
Close the cover and insert the
lower part of the filter in the
Insert lower part of the Brush
basket first and then push the
in the basket first and then
filter with “click” sound.
push the
sound.
brush with “click”
1
1
23
4
3
Clean the Brush.
1
1
23
2
4
and pull in.
BRUSH
push the
sound.
brush with “click”
To Next Page
Loading...
Need help?
General
