3
After Sales Support: 1300 886 649 (AU) | 0800 836 761 (NZ)
IMPORTANT SAFETY INSTRUCTIONS
Read this manual thoroughly before rst use and keep it in a safe place for future
reference, along with the completed warranty card, purchase receipt and carton. The
safety precautions enclosed herein reduce the risk of re, electric shock and injury
when correctly adhered to.
Electrical safety and cord handling
• Before plugging the heater into a suitable power point, make sure that your outlet
voltage and circuit frequency correspond to the voltage stated on the appliance
rating label.
• Always plug this heater into a separate power point. Do not use it with an
extension cord as this may overheat and cause a re risk.
• To ensure you do not overload the electrical circuit, make sure that no other
appliance is in use on the same electrical circuit as the heater.
• WARNING: To reduce the risk of re, electric shock or injury:
• Never touch the heater, plug or cord, or adjust any switches, with wet or damp
hands or feet.
• Do not immerse the heater in water or let water drip or spill into the heater.
• Never expose the heater to an atmospheric condition (rain, sun, etc.).
• Always place the heater on a at, stable surface.
• Do not operate the heater with a damaged cord or plug, or after the heater
malfunctions, has been dropped or damaged in any manner. In such a case,
contact the after sales support line for advice.
• If the supply cord is damaged, it must be replaced by the manufacturer or an
authorised service agent in order to avoid a hazard. Contact the after sales
support line for advice.
• Protect the power cord:
• Do not put the cord on top of or wrap it around the heater.
• Do not twist or kink the cord or let it touch heated surfaces during operation.
• Do not put any stress on the cord where it connects to the product.
• Do not pull the cord when unplugging the heater, grip the plug.
• Arrange the cord away from any trafc area so no one will trip over it.
• Do not run the cord under carpeting, throw rugs or runners etc.
• Only operate the heater with the power cord fully unwound. Using it with the
cord coiled up could cause overheating and present a re hazard.
• Do not leave the appliance unattended when connected to the mains power supply.
• To avoid the risk of electric shock, do not disassemble or attempt to repair the unit.
To Next Page
