Onkyo C-7000R User Manual

18
En
Tip
• To reduce noise, do not tie the signal cable and power cable
together. Wire them so that they are away from each other.
Note
• Never disconnect the power cord from the compact disc
player while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always disconnect the
power cord from the wall outlet first, and then the compact disc
player.
• Turning on the compact disc player may cause a momentary
power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the compact disc
player into a different branch circuit.
• Do not use a power cord other than the one supplied with the
compact disc player. The supplied power cord is designed
exclusively for use with the compact disc player and should not
be used with any other equipment.
Connecting the Power Cord
AC INLET
Compact Disc Player C-7000R
Supplied power cord
To an AC wall outlet
(Plug type varies from
country to country.)
1
Make sure that the main power of the compact disc
player is turned off.
2
Connect all of your components.
3
Connect the supplied power cord to the compact
disc player’s AC INLET.
4
Plug the power cord into an AC wall outlet.

Onkyo C-7000R Specifications

General

Frequency range	2 - 20000 Hz
Audio formats supported	MP3, WMA
Signal-to-Noise Ratio (SNR)	116 dB
Total Harmonic Distortion (THD)	0.0015 %
CD-RW playback	Yes
CD changer	No
Device type	HiFi CD player
Product color	Silver
Disc loading type	Tray
Display type	-
Digital audio coaxial out	1
Power requirements	AC 230V, 50Hz
Power consumption (typical)	18 W
Package depth	446 mm
Package width	627 mm
Package height	250 mm
Package weight	13000 g

Weight and Dimensions

Depth	315.2 mm
Width	435 mm
Height	99 mm
Weight	12000 g