Onkyo CR-725 User Manual

9
Getting to Know the CD Receiver—Continued
The page numbers in parentheses show where you can find the main explanation for each item.
aLINE 1 IN (23)
This analog audio input is for connecting a compo-
nent with an analog output, such as a TV, or a turn-
table with a built-in phono equalizer.
bMD/TAPE IN/OUT (19, 20)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output,
such as a MiniDisc recorder or cassette deck.
cDAB ANTENNA (CR-725DAB only) (15)
This jack is for connecting a DAB antenna.
dFM ANTENNA (15, 16)
This jack is for connecting an FM antenna.
eSUBWOOFER PRE OUT (18)
This jack is for connecting a powered subwoofer.
fSPEAKERS (17)
These terminal posts are for connecting speakers.
gu REMOTE CONTROL (19–23)
This u (Remote Interactive) jack can be con-
nected to an u jack on another Onkyo component.
The CD receiver’s remote controller can then be
used to control that component. To use u, you
must make an analog audio connection (RCA)
between the CD receiver and the other component,
even if they are connected digitally.
hOPTICAL DIGITAL IN (CR-725DAB only) (22)
This optical digital audio input can be used to con-
nect a component with an optical digital output,
such as a CD recorder, MD recorder, games con-
sole, satellite tuner, or personal computer. Use a
commercially available optical digital audio cable to
make the connection.
iDOCK/CDR IN/OUT (21, 23)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output
such as a CD recorder, or an Onkyo RI Dock.
jPower cord (24)
The power cord should be connected to a suitable
power source (Plug type varies from country to
country).
Rear Panel
123 4 5 6
78 9 bk
*
*
* CR-725DAB only
See pages 15–24 for connection information.

Onkyo CR-725 Specifications

General

Brand	Onkyo
Model	CR-725
Category	Car Receiver
Language	English