10
Speaker setting and distance setting
DOLBY
DIGITAL
INPUT-1
L R
Speaker setting indication
123
3
Set the ED-301 properly for your speaker system.
If your ED-301 is connected to an A/V amplifier with 5.1-channel
audio input, also perform speaker setting on the A/V amplifier.
Speaker setting
Set one of the following parameters for each speaker type.
For a typical speaker system with six speakers, set "LARGE/SMALL"
or "YES" for all speaker types.
LARGE Set this parameter if the connected speaker(s) can cover
the bass range.
SMALL Set this parameter if the connected speaker(s) cannot
cover the bass range.
YES Set this parameter if you connect a center speaker,
surround speakers, or a subwoofer.
NONE or NO Set this parameter if there is no speaker connected to
that channel and output is to be made to other speakers.
Available combination of setting for each speaker type
Speaker type Possible parameter setting
SW (Subwoofer) YES NO
L/R (Front) SMALL LARGE
Setting LARGE automatically brings
up selection for next speaker type.
C (Center) YES/NO
LARGE/SMALL/
LARGE/SMALL/NONE
NONE
LS/RS (Surround) YES/NO
LARGE/SMALL/
LARGE/SMALL/NONE
NONE
Note:
The following is the factory-set parameter for each speaker type:
SW : YES
L/R : SMALL
C : YES
LS/RS : YES
1 Press POWER.
2 Press INPUT-1 or INPUT-2.
Skip this step if the desired input mode is already selected.
Do not press MULTI-CH INPUT or you will be unable to go on to
the next and later steps.
3 Press SPEAKER repeatedly to select the speaker type for the
speaker you are setting and then press PARAMETER CON-
TROLLER repeatedly to select the parameter you want to set.
Each time you press the SPEAKER button, the speaker indicator(s)
that is blinking changes as follows.
SW (Subwoofer) → L/R (L/R Front) → C (Center) →
LS/RS (L/R Surround) → COMPLETE
Speaker setting procedure
When the setting for the current speaker type has been done, press
SPEAKER and the speaker indicator(s) for the next speaker type
will blink.
You will get out of the speaker setting mode if the speaker setting
operation is interrupted for 3 seconds or longer. To return to the
speaker setting mode in this case, press the SPEAKER button
again.
Indicator for speaker(s) being set
Speaker setting and listening mode
If system includes a Center speaker but lacks
Surround speakers...
SW : YES or NO
L/R : SMALL or LARGE
C : YES, or SMALL or LARGE
LS/RS : NO or NONE
If system lacks both a Center and Surround
speakers...
SW : YES or NO
L/R : SMALL or LARGE
C : NO or NONE
LS/RS : NO or NONE
If system includes Surround speakers but lacks a
Center speaker...
SW : YES or NO
L/R : SMALL or LARGE
C : NO or NONE
LS/RS : SMALL or LARGE
C
L
R
LS
RS
PHANTOM mode
To Next Page
Loading...
