Onkyo HTX-22HD

33
First Time Setup —Continued
Using Audyssey 2EQ
1
2, 6
3–5
1
1
Turn on the HTX-22HD.
2
Put the speaker setup microphone at
measurement point
1
(page 32), and
connect it to the SETUP MIC jack.
Notes:
•For all measurements, the micro-
phone capsule should point directly
at the ceiling.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally be
will provide better results. You can
adjust the height of the microphone
by using a tripod or level table.
• Do not attempt to hold the micro-
phone in your hand during measure-
ments as this will produce incorrect
results.
Notes:
• If the HTX-22HD is muted, it will be
unmuted automatically when the auto-
matic speaker setup starts.
• It takes about 10 minutes to complete
the automatic speaker setup for three
positions. Total measurement time var-
ies depending on the speakers.
• Do not connect or disconnect any
speakers during the automatic speaker
setup.
HTX-22HDEn.book Page 33 Monday, April 7, 2008 2:03 PM