Onkyo HTX-22HD

34
First Time Setup —Continued
Notes:
• When the automatic speaker setup is com-
plete, the Equalizer Settings (page 62) will
be set to Audyssey.
• The AUDYSSEY indicator stays on all the
time once the automatic speaker setup has
been run.
3
Press [ENTER].
Once you’ve pressed [ENTER], stand
by a wall or in a corner so that your
body doesn’t interfere with the test sig-
nals.
The automatic speaker setup starts.
You can cancel the automatic speaker
setup at any point in this procedure sim-
ply by disconnecting the setup micro-
phone.
A test tone is output by each speaker in
turn, as the Audyssey 2EQ function
determines which speakers are con-
nected. This takes a few minutes.
Note:
• Quiet the room as much as possible.
Background noise can disrupt the
room measurements. Close windows,
silence cell phones, televisions,
radios, air conditioners, fluorescent
lights, home appliances, light dim-
mers, or other devices, and refrain
from talking.
4
When the following display appears,
move the speaker setup microphone
to measurement point
2
(page 32),
and then press [ENTER].
Audyssey 2EQ performs more mea-
surements.
This takes a few minutes.
5
When the following display appears,
move the speaker setup microphone
to measurement point
3
(page 32),
and then press [ENTER].
Audyssey 2EQ performs more mea-
surements.
This takes a few minutes.
When the measurements are complete,
the results are calculated and saved
automatically.
6
When the automatic speaker setup is
complete, disconnect the speaker
setup microphone.
HTX-22HDEn.book Page 34 Monday, April 7, 2008 2:03 PM