23
Connecting AV Components—Continued
Connecting an Onkyo RI-capable component or Onkyo Dock with iPod to the HTX-22HDX
with an cable and RCA audio cable will allow you to use the following system control func-
tions. An cable is a special cable for use with Onkyo’s (Remote Interactive) control
system.
Auto Power On/Standby
If you turn on or start playback on the Onkyo RI-capable component or Onkyo Dock with iPod,
the HTX-22HDX will automatically turn on and select the RI-capable component or iPod as the
input source. Similarly, when the HTX-22HDX is set to Standby, the Onkyo RI-capable compo-
nent or Onkyo Dock with iPod will also go on Standby.
Direct Change
When playback is started on the Onkyo RI-capable component or Onkyo Dock with iPod, the
HTX-22HDX automatically selects the RI-capable component or iPod as the input source.
Remote Controller Operation
In addition to controlling the HTX-22HDX, you can also use the HTX-22HDX’s remote control-
ler to control an Onkyo RI-capable component or Onkyo Dock with iPod. When doing so,
remember to point the remote controller at the HTX-22HDX and not at the RI-capable compo-
nent or Onkyo Dock. Hookup information is shown below. The remote controller buttons that
you can use to control an Onkyo RI-capable component or Onkyo Dock with iPod are explained
on pages 25 and 26.
■ Hookup
The following diagram shows how to connect an Onkyo RI-capable component and RI Dock
with iPod to the HTX-22HDX for operation. Use the cables supplied with the RI-capable
component and RI Dock. An cable is not supplied with the HTX-22HDX.
Connecting Onkyo Components
To Next Page
Loading...
