27
Turning On the HTX-22HDX
Before connecting the power cord, connect
all of your speakers and other components.
1
Connect the supplied power cord to the
HTX-22HDX’s AC INLET.
2
Plug the other end of the power cord
into a suitable wall outlet.
The STANDBY indicator lights up.
Notes:
• Turning on the HTX-22HDX may cause a
momentary power surge that might inter-
fere with other electrical equipment on the
same circuit. If this is a problem, plug the
HTX-22HDX into a different branch cir-
cuit.
• Do not use a power cord other than the one
supplied with the HTX-22HDX. The sup-
plied power cord is designed exclusively
for use with the HTX-22HDX and should
not be used with any other equipment.
• Never disconnect the power cord from the
HTX-22HDX while the other end is still
plugged into a wall outlet. Doing so may
cause an electric shock. Always disconnect
the power cord from the wall outlet first,
and then the HTX-22HDX.
On the HTX-22HDX, press the
[ON/STANDBY] button.
On the remote controller, press the
[ON/STANDBY] button.
The HTX-22HDX comes on, the display
lights up, and the STANDBY indicator goes
off.
To turn off the HTX-22HDX, press the
[ON/STANDBY] button, or press the remote
controller’s [ON/STANDBY] button. The
HTX-22HDX will enter Standby mode. To
prevent any loud surprises the next time you
turn on the HTX-22HDX, turn down the vol-
ume before you turn it off.
Connecting the Power Cord
To Next Page
Loading...
