Advanced Settings
57
Setting Item Default Value Setting Details
Pairing Information – When paring is performed, the information of
the previous pairing stored in this unit will be
initialized.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored in this
unit.
r
This function does not initialize the pairing
information on the Bluetooth-enabled device.
When pairing the unit again with the device,
be sure to clear the pairing information on
the Bluetooth-enabled device in advance.
For information on how to clear the pairing
information, refer to the Bluetooth-enabled
device's instruction manual.
Device – Displays the name of the Bluetooth-enabled
device connected to the unit.
r
The name is not displayed when "Status" is
"Ready" and "Now Pairing...".
Status – Displays the status of the Bluetooth-enabled
device connected to the unit.
"Ready": Not paired
"Now Pairing...": Paired
"Connected": Successfully connected
r
Wait for a while if "Bluetooth" cannot be selected. It will appear when the network function is started
up.
Firmware Update
Setting Item Default Value Setting Details
Update Notice Enable Availability of a firmware update will be notified
via network.
"Enable": Notify updates
"Disable": Do not notify updates
Version – The current firmware version will be displayed.
Update via NET – Press ENTER to select when you want to update
the firmware via network.
r
You will not be able to select this setting if you
do not have Internet access or there is nothing
to update.
Setting Item Default Value Setting Details
Update via USB – Press ENTER to select when you want to update
the firmware via USB.
r
You will not be able to select this setting if
a USB storage device is not connected or
there is nothing to update in the USB storage
device.
r
Wait for a while if "Firmware Update" cannot be selected. It will appear when the network function is
started up.
Initial Setup
You can make the initial setup from the setup menu.
r
Wait for a while if "Initial Setup" cannot be selected. It will appear when the network
function is started up.
To Next Page
Loading...
Need help?
General
