113
Zone 2 and Zone 3
—Continued
Muting Zones
Adjusting the Tone of Zone 2
Notes:
• Zones can also be unmuted by adjusting the volume.
• The tone cannot be adjusted for Zone 3.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the Zone 2 Out
setting is set to Fixed (page 110).
• The Zone 3 level and balance functions have no effect
on the ZONE 3 PRE OUT when the Zone 3 Out set-
ting is set to Fixed (page 110).
On the remote controller, press
the [ZONE 2] or [ZONE 3]
REMOTE MODE button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2] or
[ZONE 3] REMOTE MODE button,
and then press the [MUTING] but-
ton again.
1
On the AV controller, press the
[ZONE 2] button.
2
Press the AV controller’s [TONE]
button repeatedly to select Bass
or Treble.
3
Use the Up [ ] and Down [ ]
buttons to adjust the bass or tre-
ble.
You can boost or cut the Bass or Treble
from –10 dB to +10 dB in 1 dB steps.
ZONE
3
ZONE
2
MUTING
ZONE 2
AV controller
TONE
PR-SC885En.book Page 113 Tuesday, February 26, 2008 2:07 PM
To Next Page
Loading...
Need help?
General
