Onkyo T-411RDS-409 User Manual

Using preset stations
i Using Auto Memory >
... ~ *** '*£ v- .. .•
E (FM mode only)
This function allows you to store the fre¬
quencies into memory automatically, with¬
out having to go through and store each
frequency manually. If the Auto Memory is
used, all FM stations previuosly stored in
memory will be replaced.
1. Use the BAND button to select FM.
2. Hold down the memory button for a
few seconds. “AUTO’ % will start flash¬
ing on the displav.Keep holding down
the button for a few more seconds to
start the Auto Memory function.
The frequencies are scanned from low' fre¬
quencies to high frequencies, and the
broadcast signals with the best signal qual¬
ity are selected, and stored into memory.
The stations will be stored from the lowest
to the highest frequency.
Up to 20 stations can be stored in total.
Selecting preset stations
1. Use the KEY MODE button to enter
PRESET mode. The PRESET indica¬
tor will light up.
2. Use the ◄ TUNING / PRESET ► but¬
tons to select the desired preset.
The Tuner will automatically switch to
AM or FM according to the station
Q
selected.
Cancelling preset stations
1. Select the preset station as explained
in the previous section.
2. Press and hold the MEMORY button
and within a second of doing this,
press the AUTO/MONO button.
will be shown on the MEMORY
channel display.
Note that if you fail to press the AUTO/
MONO button while holding down the
MEMORY button, the AUTO^ MEMORY
will start.

Onkyo T-411RDS-409 Specifications

General

Brand	Onkyo
Model	T-411RDS-409
Category	Tuner
Language	English