Onkyo T-411RDS-409 User Manual

Using preset stations
Programming radio stations
For example, to enter a station at 98.00
MHz (FM) into number 3 in the Preset
Memory:
1. Use the KEY MODE button to enter
TUNING mode.
2. Use the BAND button to select FM.
3. Use the ◄ TUNING/PRESET ► but¬
tons to select the frequency (98.00
MHz).
If the ◄ TUNING/PRESET ► buttons
are held down for more than 0.5 sec¬
onds, when they are released scanning
will continue automatically.
Scanning will stop when a station is
tuned into.
4. Press the MEMORY button.
The memory indicator and the PRESET
indicator will light up.
5. Use the ◄ TUNING/PRESET ► but¬
tons to select the preset number to
store into (3).
6. Press the MEMORY button to store
the frequency into the selected preset.
Notes:
• AM stations can be stored in the mem¬
ory using the same procedure.
• Up to 30 FM and AM stations can be
stored in the preset memory in total.
• If the FM station received is an RDS
station with a PS (Program Service
Name), the frequency display will
change to the PS display.
If there is no PS, the frequency display
will not change. (Refer to page 12 for
the RDS function.)
Listening to a stereo radio
station
If you tune in a stereo FM station, the STE¬
REO display will be illuminated if the sig¬
nal is sufficiently strong.
If the signal is weak, it may be impossible
to tune into your desired station. In this
case, tune in as follows.
1. Press the AUTOAIONO button and
the MONO display lights.
2. Select the station you would like to
listen to using the ◄ TUNING/PRE¬
SET ► buttons.
9

Onkyo T-411RDS-409 Specifications

General

Brand	Onkyo
Model	T-411RDS-409
Category	Tuner
Language	English