Onkyo T-488F - Page 11

PTY SCAN (Programme Type Scan)
Use this to look for a broadcast station from the desired program type.
AF SEARCH (List of Alternative Frequencies Search)
The receiver selects the station with the strongest radio wave of the broadcast currently received.
=e hee eee
Baan ees
ae Be
cs co oO
:
®
AUTO MEMORY (Only FM)
@® Press the PTY button.
@ \fPTY is available for the station currently being received, it will
be displayed. if PTY is not available, “NONE?” will be displayed.
On the other hand, if the receiving station is not an RDS station,
“Not RDS’ will be displayed.
® Press the UP/DOWN button to display the desired program type.
(Please see the table on the left hand side of the page.
®@ \fyou donotcarry out the above operation within 3 seconds after
pressing the PTY button, you must start again from step ®.
@ Press the SCAN/S.LETTER button.
®@ Scanning will start from the current frequency sequentially. If
there is a station which is broadcasting the program type
selected in step @, the frequency of the station will be displayed
for 5 seconds. If you do nothing, scanning will start again.
© {f, instep ©, “NONE” or “Not RDS’ is displayed and the SCAN/
S.LETTER button is pressed, “Type?” will be displayed. If this
occurs, start again from step @ and choose a program type.
®@ if a CABLE frequency is being received when the SCAN/
S.LETTER button is pressed, CABLE is automatically turned
OFF.
@ When the desired broadcast station is found during scanning,
press the SCAN/S.LETTER button.
@ The frequency of the station will be displayed. If a PS function
is available for the station, PS will be displayed.
@ {f there is no broadcast of the desired program type within the
selected band, “Not find” will be displayed, and the original
frequency will return.
® Stop scanning by pressing the SCAN button again, or by
pressing any other button.
®. Press the AF SEARCH button
If the receiving station is a RDS station, “AF” is displayed for one
second, then the function searches the AF listed stations sequen-
tially. The frequency with the strongest meter signal will be dis-
played. If PS is available it will be displayed after that.
If no stations are listed in the AF list, “No list” will be displayed, and
PS, if available, will also then be displayed. If you press a button
other than the tuning buttons during the search, the search stops
and the frequency at that point remains. If PS is available, it will be
displayed.
If the receiving station is not a RDS station, “Not RDS” will be
displayed and the frequency display will return after 3 seconds.
AUTO MEMORY searches frequencies sequentially and automatically memorizes up to 20 stations in CLASS F.
However, broadcast stations with the same program cannot be memorized if they overlap each other.
NOTE:
When AUTO MEMORY is carried out, the stations memorized up
to that point are all deleted.
@ Press the AF SEARCH button for more than 2 seconds while
holding down the MEMORY button. “AUTO” starts flashed and the
following AUTO MEMORY operation will begin.
All the preset memories are deleted.
2. Frequencies from 87.50 MHz to 108.00 MHz are searched.
® Stations will be written in CLASS F. When itis finishing, PS of
the last station is displayed. If PS is not available, the frequency
is displayed.
3. If the number of memory stations is more than 20, frequencies up
to 108.00 MHz are searched and then PS of the 20th station is
displayed. If PS is not available, the frequency is displayed. If there
is no memory station, 108.00 MHz is displayed. If you press a
button during the search, the search stops and the current fre-
quency will remain.
—
—~10—