Onkyo T-488F - Page 7

Using the remote control transmitter RC-248T
IF Bandwith Selector Button
(IF BAND) [8]
Hi-Blend Selector Button
(HI-BLEND) [8]
RF Mode Selector Button
(RF MODE) [8]
Antenna Selector Button
(ANTENNA) [8]
Number and Character Buttons
(1~9, 0) [7]
* Characters cannot be entered
with the remote control transmitter.
REMODE IF AAND HLGLEND MODE
4
ANTENNA
Auto Stereo/Mono Selector Button
(MODE) [8]
Scan Button (SCAN) [10]
Al FED
=|} OIRECT
CABLE
REMOTE CONTROL TRANSMITTER RC 248T
“— Classified Memory Button
(CLASSIFIED) [11]
Direct Tuning Button
(DIRECT) [7]
Cable Button (CABLE) [8}
Using the remote control transmitter
1.
2.
Remove the batteries if the remote control transmitter is not going
to be used for a long time.
The batteries of the remote control transmitter must be replaced
periodically.
. This unit uses infrared rays. Therefore, commands may not be
received properly if the front panel of this unit is exposed to bright
light. To prevent this from occurring, place this unit so that it is not
directly exposed to bright light.
. If this unit is placed inside an audio rack behind a glass door, the
door should not have colored glass or have any decorations on it,
since this could shorten the range or prevent commands from being
received.
. Use of other infrared remote control devices in the same room may
cause interference.
. The transmitter operates up to a distance of about five meters (16
feet). The transmitting window must always be pointed at the
reception window when a command is sent to the T-488F.
. If this remote control transmitter does not operate properly, confirm
that the batteries are not dead. If the problem persists, contact your
Onkyo Service Center.
Remote control transmitter RC-248 T
approx. 5m
(16 feet)