Onkyo TX-906 - Multi-Room Listening Setup; Simul Source Operation; Remote Control for Sub Room

Listening to devices connected to the
TX-906/904 in another room
ea
@
TX-906/904
allows
you
to
listen
ta
the
desired
performance
in
another
room
(sub
room)
while
listening
to
the
playback
of
a
device
located
In
the
main
room.
To
do
this,
connect
the
speakers
in
another
room
to
the
FRONT
SPEAKERS
REMOTE
terminals
on
the
TX-906/904.
®
Remote
control
from
another
room
can
be
done
by
employing
the
ONKYO
multiple
room
remote
system
(
IMR).
Refer
to
the
connections
for
multiple
room
remote
control.
Be
sure
to
operate
the
remote
control
unit
directing
to
the
remote
sensor
unit
HR-10.
®@®
The
following
steps
(except
step
))
can
be
performed
using
the
remote
control
unit.
It
is
recommended
that
the
adjustments
described
below
be
done
in
the
main
room
in
advance,
since
it
is
not
possible
to
operate
the
remote
control
unit
in
another
room
while
watching
the
display
of
the
TX-906/904.
@SIMUL SOURCE
Make sure that recording is not being carried out before setting the
TX-906/904.
Turn the MR OFF button OFF ( MR indicator is turned off.)
@ ar OFF
Press the SIMUL SOURCE button.
@ [REC OUT> indicator will be turned off and the
indicator will flash for 8 seconds.
While this is flashing, use the input selector button to select
the desired source.
° will light and the selected source will
be marked with a red frame.
@® At this time, the display will show the tuner indications for
© seconds and between the scanning of the CLASSIFIED
SCAN programs if the tuner has been selected. PRESET
station of the tuner can be selected during this indications.
Adjust the jevel using the SIMUL SOURCE UP/DOWN buttons
of the remote control! transmitter.
ad and the level will be indicated on the display. It
is recommended that the level be set lower in advance in
the main room (-—79 ~ —78dB).
Press the REMOTE button of the SPEAKERS to i!fuminate
the[REMOTE] indicator.
@ Press the MAIN button to turn off the indicator if
you are not listening the sound in the main room.
When changing the source, be sure to press the SIMUL
SOURCE button before pressing the input selector button.
Pressing
the
input
selector
button
without
first
pressing
the
SIMUL SOURCE button will change the source in the main
room.
3)
3)Source required
© Speaker Selector
REMOTE
iP ated
LPT
4 SIMUL SOURCE
UP/DOWN
©)
@ The surround mode is turned off (bypassed) when controlling
MR Off button ( MR OFF) and Indicator
the SIMUL SOURCE while listening the surround sound in
the main room. (TX-906 only)
The same source as that indicated by the input selector will
be output for the REC OUT of the TAPE-1,2, VIDEQ-2 if the
SIMUL SOURCE is controlted.
Press the REC OUT button to change the SIMUL SOURCE
mode to the Surround mode or REC OUT selector modes.
M@ You can use the remote contro! transmitter supplied with this
Tuner Amplifier to operate the source devices selected for the
simul source if they are an ONKYO CD or cassette deck bearing
the FRI mark.
There is aremote control unit RC- MR1H for the Sub room, which
is sold separately.
Installment of the ramote sensor unit HR-10 and the remote
emitter unit HE-50(AC) is required to control non-ONKYO
devices from another (sub room). Operate the remote contro!
unit included with the device by directing the contro! unit toward
the HR-10 installed in another room (sub room).
This
is
used
to
disable
control
of
the
ONKYO
MR
system
via
the
remote
control
unit
in
another
room.
Pressing
this
button
will
tiluminate the
indicator,
and
control
from
another
room
will
be
disabled.
Pressing
the
button
again
will
turn
the
indicator
off,
and
control
from
another
room
will
be
enabled.
NOTES:
e
e
lf the simul source is selected, the MR OFF will be off.
lf the simul source ts selected for REC OUT, and the SUR-
ROUND MODE key is selected, the M12 OFF will be on.
a
@ IF A PROBLEM OCCURS, use the TX-906/904's front pane!
controls to verify that the problem is with the remote controller.
If there is no problem when operating the TX-906/904 directly,
check the batteries in the remote controller first before assuming
that there is a controller malfunciton.
NOTES:
16 —
® The source may be changed or recording being done on the
TX-906/904 may be interrupted when operations are done
in the another room. Press the MR Off Button to disable
(The MR indicator will be
the controi from another room.
illuminated. )
some non-ONKYO remote control transmitters cannot be
used.