Need help?Do you have a question about the Onkyo TX-903 and is the answer not in the manual?
General| Power Output | 50 watts per channel into 8Ω (stereo) |
|---|---|
| Number of Channels | 2 |
| Total Harmonic Distortion (THD) | 0.08% |
| Frequency Response | 20Hz to 30kHz |
| Input Sensitivity | 2.5 mV (MM), 150 mV (line) |
| Signal-to-Noise Ratio | 80 dB (MM), 100 dB (line) |
| Speaker Impedance | 4-16 ohms |
| Tuning range | FM, AM |
| Speaker load impedance | 8 ohms (minimum) |
Lists included accessories such as AM loop antenna and T-shaped FM antenna for setup.
Instructions for correctly inserting batteries into the remote control transmitter.
Basic rules for connecting the unit, including power switch and channel connections.
Guidance on connecting FM antennas based on signal strength and cable types.
Instructions for connecting a turntable, emphasizing proper grounding to prevent hum.
How to connect speakers, emphasizing polarity and impedance for optimal sound.
Explains connecting components via RI for remote control operation.
Identifies and explains the function of all buttons, knobs, and indicators on the front panel.
Step-by-step guide on how to select an input source and adjust volume.
Instructions for tuning FM/AM stations, including direct tuning and APR system.
How to classify and memorize radio stations into different categories.
Procedures for recording audio from various sources and dubbing between tape decks.
To Next Page
