Onkyo TX-903 - Classified Memory Function

( pot y Fun ct on.
The memory can be divided (classified) for different users or pro-
grams of stations.
BM How to classify stations
With this model, six classes (CLASS A to F) are available and
stations can be memorized in any class. A total of 40 stations
can be memorized in classes from A to F. Although the same
station can be memorized in different classes, the memory
number for the station will differ depending on the order in which
the station is memorized in the classes.
(2) MEMORY
(3) CLASS A~F
NOTE:
There are times when frequencies are left in the machine's me-
mory from the final testing done prior to shipment. tf this is the
case with your TX-903/901, cancel unnecessary preset stations
according to “How to cancel memorized stations” and memorize
desired frequencies.
a) Tune in the desired station (see section on “Tuner Reception" }.
(2) Press the MEMORY button.
@ The MEMORY indicator will flash for 8 seconds.
3) Press the desired Classified Memory button (one of buttons A
to F).
@® The station ts memorized in the selected class with the me-
mory number which is the smallest of the unoccupied
numbers in the class.
By repeating the operations above, up to 40 stations can be me-
morized. If an attempt is made to memorize 41 stations,
“FULL” will be displayed in the Input Selector/Frequency Display,
indicating that no more stations can be memorized.
@ How to cancel memorized stations
Retrieve the class number you want to cancel (see “How to
retrieve memorized stations”) and then press the MUTE/MODE
button while holding down the MEMORY button. Another
station can be memorized with the memory number which has
been cancelled.
@ How to retrieve memorized stations
a) Press the Classifted Memory button for the desired class. If
remote control is used, the class next to the present one is re-
trieved when the CLASS button is pressed. (TX-903 only)
@ The memory number (station) which was being received
before the class is retrieved will be recetved.
(2) There are several methods to proceed after the above operations
are carried out. Use any of the following methods.
a. Pressing the same Classified Memory button again permits
the next preset memory number (station) to be received.
b. input the memory number you wish to receive by using the
Number buttons.
® Ifthe memory number consists of 2 digits, input two numbers,
immediately one after the other. For instance, when inputting
"45", “15° will not be registered if you wait more than one
second before inputting “5”, resulting in only "1" being re-
gistered.
lf a number other than a number from 1 to 40, or a number
which has not been memorized is input, the number flashes
for 2 seconds and then the number which was displayed
before will be displayed.
® \f a number between 1 and 4 is pressed, the display and
station are changed 71 second later.
c. Whenthe <« PRESET ® button of the remote controller
is pressed, the memory number of the class currently being
received will be incremented or decremented. Keeping
pressing the button increments or decrements continuously.
After the maximum or minimum number is reached, the next
class or one before the present class will be entered.
(TX-303 only)