Onkyo TX-903 - Tape Recording and Dubbing

T
Oo
900 © Og
Make ail connections between the tape deck and the unit as
shown in the System Connections Diagram.
Radio: Press the FM or AM Input Selector button.
Record: Press the PHONO Input Selector button.
CD: Press the CD Input Selector button.
Put the tape deck in the recording mode. The recording can be
monitored through the speakers or headphones as desired. For
TAPE-2, turn on the corresponding Tape Monitor button to hear
the signal that, having been recorded, is returned from the deck
to the TX-903/901. (if the deck has three heads}.
Set the proper recording level using the controls on the tape
deck used for recording. Also, during recording and dubbing
operations, never change the positions of any controls (bass,
treble, etc.) on this unit.
Connect the two tape decks to this unit as shown in the System
Connections diagram.
Load the original tape in tape deck 1 and the blank tape in tape
deck 2.
Press the TAPE-1 Input Selector button.
Put tape deck 1 in the playback mode and tape deck 2 in the
recording mode.
The source signal can be monitored through the speakers or
headphones, when the TAPE-2 MONITOR button is in the OFF
position. If tape deck 2 has three heads, the just-recorded signal
can be monitored (when the TAPE-2 MONITOR button is in
the ON position). Refer to the tape deck instruction manuals
for more details.
9 the Graphic Equalizer
onnect the graphic equalizer to the TAPE-2 jacks on the rear
panel.
If a second tape deck is used, connect it to the tape jacks on
the graphic equalizer.
Press the TAPE-2 MONITOR button.
Follow the graphic equalizer operating instructions.
To record an equalized signal, use tape deck 2 (connected to
the equalizer) for recording.