Onkyo TX-903 - Operations; Listening to Your Favorite Source

Operations
(3) SPEAKERS and HEADPHONES
(6) VOLUME
4
OOO
|
© © O
Lo }
(1) MAIN POWER
(7) Tone Controls
(4) Input Selector Buttons
(2)
SYSTEM
POWER
(5)
Starting
Source
Selected
at
(4)
(TX-903 only)
qd) Press the POWER switch to turn on the power. Press this switch
@)
@)
to switch the on/off status of the power supply.
Press this button to turn on power and the AC outlets on the
rear pane! when the unit is in the standby mode. Power can also
be turned on by using the remote control power button (TX-903
only)
Select the desired pair of speakers by depressing the corre-
sponding speaker selector switch.
® This unit can drive two pairs of speakers in pairs {A or B)
or fours (A + B). To listen to both speaker systems at once,
depress both speaker selector switches.
® Stereo headphones with a standard binaural p!ug can be
connected here.
Press one of the desired Input Selector Button (CD, PHONO,
FM, AM, TAPE-1/VIDEQO).
Make sure that the connections between the input sources are
correct.
@® The button pressed is shown in Display. For FM or AM, the
band and the frequency are shown in Display.
® Confirm that the TAPE-2 MONITOR indicator is off when
a source other than the TAPE- 2 MONITOR has been selected.
Also check the audio muting is off. (TX-903 only)
6) Start play of the selected input source.
@ Follow the operating Instructions of that unit.
@ |tf FM or AM is selected, please refer to the section “Tuner
Reception’.
(6) Adjust the Volume Control knob to the appropriate level.
® Turn clockwise to increase the volume level. The volume
can be adjusted manually and by the remote control
transmitter’'s Volume UP/DOWN button. (TX-903 only)
(7) Adjust the Tone Controls to obtain the desired tone setting.
@ Bass Control Knob (BASS)
Adjust to strengthen or weaken bass response.
@ Treble Control Knob (TREBLE)
Adjust to strengthen or weaken treble response.
@ Balance Control Knob (BALANCE)
Use this control to adjust the relative volume levels of the
left and right speaker systems.
@ Loudness Control Switch (LOUDNESS)
When listening at low volume levels, depress this switch to
boost the very high and very tow frequencies to provide a
more natural sound.