Onkyo TX-903 - Before Using This Unit; Supplied Accessories; Transmitter Battery Insertion (TX-903 only)

Before using this unit
1. Supplied Accessories
— —~ TX-903 only
AM
loop
T-shaped
FM
FRI
remote
control
cable
x
1
Remote
contro!
transmitter
x
1
antenna
x
1
antenna
X
1
Battery x 2
Use of Batteries
@ The remote control transmitter is powered by two batteries.
Before using this unit for the first time. tnsert the two batteries
(included) as shown in the diagram.
@ Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment (temper-
ature and humidity) in which the remote contro! transmitter «s
used.
® If the remote control transmitter does not operate even though
front panel controls function normaily, the batteries should be
replaced. Use only battertes listed in the following chart.
Type Voltage
nese
4) Push the battery cover on the rear of the transmitter in the di- . Do not leave an expired battery in the case as it may leak
rection of the arrow and lift !t up. or damage the battery case.
(2) Load the two batteries that came with the transmitter or two . When inserting the batteries, be sure the (+) and (—) ends
battertes listed in the table. Load them with the + and — ends are properly aligned.
facing as shown in the diagram. . Do not use nickel-cadmium (rechargeable) batteries.
(3) Put the battery cover back in place. . Do not use one specified (manganese) battery and one al-
kaline battery at the same time.
Replace both batteries at once; do not use one old and one
new battery together.