Onkyo TX-906 - Page 5

Before using this unit
eee eee eee ee
1. Supplied Accessories
T-shaped FM
antenna X 1
AM loop
antenna x 1
2. Transmitter Battery Insertion
@
ON
~f
eS
Precautions when using batteries
® The remote controi transmitter is powered by two batteries.
Before
using
this
unit
for
the
first
time,
insert
the
two
batteries
(included) as shown in the diagram.
@ Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment (temper-
ature
and
humidity)
in
which
the
remote
control
transmitter
is
used.
fRi remote control cable x 1
Remote control transmitter x 1
Batteries x 2
@ if the remote control transmitter does not operate even though
front panel controls function normally, the batteries should be
replaced. Use only batteries listed in the following chart.
Do not leave an expired battery in the case as it may leak
or damage the battery case.
When inserting the batteries, be sure the (+) and (~) ends
are properly aligned.
Do not use nickel-cadmium (rechargeable) batteries.
Do not use one specified (manganese) battery and one al-
kaline Battery at the same time.
Replace both batteries at once; do not use one old and one
new battery together.
Using the remote control transmitter
1.
The
batteries
of
the
remote
contral
transmitter
must
be
replaced
periodically.
2.
This
unit
uses
infrared
rays.
Therefore,
commands
may
not
be
received
properly
if
the
front
panel
of
this
unit
is
exposed
to
bright
light.
To
prevent
this
from
occurring,
place
this
unit
so
that
it
is not
directly
exposed
to
bright
light.
3. If this unit is placed inside an audio rack behind a glass door,
the door should not have colored glass or have any decorations
on it, since this could shorten the range or prevent commands
from being received.
4.
The
transmitter
operates
up
to
a
distance
of
about
five
meters
(16
feet).
The
transmitting
window
must
always
be
pointed
at
the
reception
window
when
a
command
is
sent
to
the
TX-906/904.
5.
lf
this
remote
control
transmitter
does
not
operate
properly,
confirm
that
the
batteries
are
not
dead.
If
the
problem
persists,
onta ur ONKY ervice Center.
c ct yo 0 OS ce TX-906/904
Remote sensor
approx. 5m
(16 feet)
Remote control transmitter
Memory Preservation
This
unit
does
not
require
memory
preservation
batteries.
A
built-in
memory
power
back-up
system
preserves
the
contents
of
the
memory
during
power
failures
and
even
when
the
unit
is
unplugged.
The
unit
must
be
piugged
in
in
order
to
charge
the
back-up
system.
The
memory
preservation
period
after
the
unit
has
been
un-
plugged
varies
depending
on
climate
and
placement
of
the
unit.
On
the
average,
memory
contents
are
protected
over
a
period
of
a
few
weeks
after
the
last
time
the
unit
has
been
unplugged.
This
period
is
shorter
when
the
unit
is
exposed
to
a
highly
humid
climate.