Onkyo TX-RZ840

80
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting ZONE B
Connecting a Pre-main Amplier, etc. (ZONE B)
While performing playback through speakers (ZONE A) connected to the unit,
you can enjoy the audio of the same source at the same time with the pre-main
amplier or the transmitter of the wireless headphones connected to the ZONE
B LINE OUT jack. Use an analog audio cable to connect the ZONE B LINE OUT
jack of this unit and the LINE IN jack of the pre-main amplier or the transmitter of
the wireless headphones.
Press the Q button on the remote controller for playback, and select the audio
output destination on the Quick menu. ( p119)
Setup
• Settings are required to output audio to ZONE B. Press on the remote
controller, and set "2. Speaker" - "Conguration" - "Zone 2 Preout" ( p158)
to "Zone B".
a Analog audio cable
LINE
IN
OR
a
Premain Amp.
Transmitter