Need help?Do you have a question about the Onkyo TX-SV414 and is the answer not in the manual?
General| Tuning range | FM, AM |
|---|---|
| Input sensitivity | 2.5mV (MM), 200mV (line) |
| Video Connections | Composite |
| Preset Stations | 30 |
| Total Harmonic Distortion (FM) | 0.5% |
| Total Harmonic Distortion (AM) | 0.8% |
| Frequency Response (FM) | 30Hz to 15kHz |
| Type | Stereo Receiver |
| Power output | 60 watts per channel into 8Ω (stereo) |
| Total harmonic distortion | 0.08% |
| Speaker load impedance | 4Ω to 16Ω |
| Tuning Range (FM) | 87.5 to 108 MHz |
| Signal-to-Noise Ratio (FM) | 73dB |
Explains how to set the voltage selector on worldwide models.
Explains how to set the tuning step frequency for AM and FM bands.
Details the controls and their locations on the front panel of the TX-V940/TX-V940RDS and TX-SV414PRO models.
Details speaker impedance requirements for front, center, and rear speakers.
Details how to select audio sources and adjust volume and tone controls.
Guides manual and direct tuning methods for radio stations.
Explains how to store radio frequencies into memory presets.
Guides selecting stored radio stations using unit buttons.
Step-by-step guide to entering station names for presets.
Explains how to modify existing station names.
Details the process of recording audio from various sources to a tape deck.
Provides guidance on optimal speaker placement for surround sound.
Details recommended placement for the center speaker.
Describes using the test tone for speaker volume adjustment.
Explains how to adjust the delay time for surround sound effects.
Details connecting Onkyo components using RI cables for remote operation.
To Next Page
