Onkyo W800BT - Use Your Headset; Connect the Headset to a Bluetooth Device; Operate Your Headset

7EN
4 Use your
headset
Connect the headset to a
Bluetooth device
1
Turn on your mobile phone/Bluetooth
device.
2
Press and hold the power on/o button
for 2 seconds on both sides of the
headset.
 The white LED light on the left side
of the headset flashes slowly after
pairing with the right side of the
headset.
 The white LED light on the right side
of the headset flashes rapidly. The
headset is ready to pair with the
Bluetooth device.
 The headset is reconnected
to the last connected mobile
phone/Bluetooth device
automatically.
Tip
• If you turn on the mobile phone/Bluetooth device
or activate the Bluetooth feature after turning on
the headset, you have to reconnect the headset and
mobile phone/Bluetooth device manually.
• If your mobile phone/Bluetooth device cannot
reconnect automatically, try to reconnect
manually by clicking the headset's name again
under the Bluetooth setting menu on your mobile
phone/Bluetooth device.
Note
• If the headset fails to connect to any Bluetooth
device within range in 5 minutes, it will switch o
automatically to save the battery life.
Operate your headset
On/o
Task Button Operation
Turn the
headset
on.
On/o,
call control
Press and hold for
2 seconds.
 You hear a
power on
signal tone.
Turn the
headset
o.
on/o,
call control
Press and hold for
4 seconds.
 The white
LED is on for
2 seconds
and then the
headset is o.
 You hear a
power o
signal tone.
Call control
Task Button (right
headset)
Operation
Pick
up/hang
up a call.
On/o,
call control
Press once.
Reject an
incoming
call.
On/o,
call control
Press and
hold for 2
seconds.