Onn 100010108 - Safety, Parts, and Hardware; Safety Warnings; Assembly Tips; Parts List and Hardware

SAFETY WARNING:
Never let children climb on the product or play with product.
2.Do
not
sit
or
stand
on
product.
3.Do
not
fasten
a
TV
that
is
heavier
than
the
recommended
load
rating
to
the
mount.
4.Using suitable concrete wall or wood stud wall.
5.lmproper installation may cause property damage and/or personal injury, so the
installation
must
be
done
by
two
qualified
contractors.
The
manufacturer
is
not
liable
for
damage
or
injury
caused
by
incorrect
mounting,
assembly
or
use.
6.lmproper handling can result in cuts or lacerations.
ASSEMBLY TIPS:
1.Become
familiar
with
the
instructions
and
all
parts.
2.Make sure that all parts are in the box and in good condition.
3.Assemble the product on the open flat carton or a rug to protect the product
and your floor.
4.Some
heavy
products
need
a
second
person
to
assist
in
the
assembly.
Do
not
install on sloping surface.
ACAUTION
:
This
mount
is
intended
for
use
with
TV
weights
not
exceeding
“maximum weight capacity The wall itself has to be capable of supporting
4X standard weight. Please don't over tighten screws in order to avoid any injury.
Use with products heavier than the maximum weights indicated may result in
collapse
of
the
mount
and
its
accessories
causing
possible
injury.
@ Parts list:
B--Extension arm
2 pcs
ee
D--Bracket
A--Wall
plate C--Extension arm
Tpc
2pcs
pT
E--Plastic
cover
F--Plastic
cover
G--End
support
H--Hanging
template
2pcs 2pcs Tpe
@ Wall mounting and TV bracket assembly hardware:
me
[ax]
©)
0
|
|
2G
G--Bubble
~Anchor
pes level
bolt
K--M8
washer
L--M5x12
screw
screw
apes pes 2pes
screw
O--Méxt2
screw
P--
Allen
key
Apes pes Ipc
@
TV
mounting
hardware:
screw
screw ¢--MBx20 screw screw screw screw
pes
4pes
4
pes
Apes
be-Mé
spacer
i--MBspacer j--lOmm spacer
k--25mm
spacer
washer
m--Md
wosher
4
pes
4pes
Bpes
4pes
Step
1:
Please
choose
proper
wall
plate
pattern
according
to
your
wall
condition.
(Figure 1)
Pattern 1:
.
For
16"
wood
studs
16 or concrete wall
Wall
plate
Pattern
2:
Turnover
parts
©
from
plate,
use
allen
key
(P}
to
tighten
screws
(N)
into
wall
plate,
then
parts
@
are
fixed
with
wall
plate.
=i
For
24°
wood
studs
or
concrete
wall
Figure 1