Page 18
HMS 1100 Modules / Output
Unit Numbers Unit Numbers
193 - 208 X-10 modules 1 - 16, House Code X+12
209 - 224 X-10 modules 1 - 16, House Code X+13
(193 - 223) ALC addresses 1-31, Module 2 - Branch 1 *
225 - 240 X-10 modules 1 - 16, House Code X+14
241 - 256 X-10 modules 1 - 16, House Code X+15
(225 - 255) ALC addresses 1-31, Module 2 - Branch 2 *
257 - 272 Outputs 1-16, 1st Expansion Enclosure *
273 - 288 Outputs 1-16, 2nd Expansion Enclosure *
289 - 304 Outputs 1-16, 3rd Expansion Enclosure *
305 - 320 Outputs 1-16, 4th Expansion Enclosure *
321 - 336 Outputs 1-16, 5th Expansion Enclosure *
337 - 352 Outputs 1-16, 6th Expansion Enclosure *
353 - 368 Outputs 1-16, 7th Expansion Enclosure *
369 - 384 Outputs 1-16, 8th Expansion Enclosure *
385 - 392 Voltage Outputs (1-8), Fully Configurable
393 - 511 Internal Flags
Notes:
"X" Represents the House Code setting on the HMS 1100.
"*" If used.
Scrolling Through Names
The HMS 1100 stores names for Units, Zones, Buttons, Codes, Temperatures, and Messages so that you don't have to remember
that "UNIT 5" is the "DEN LIGHT" and "ZONE 1" is the "FRONT DOOR". In general, any time you enter a unit, zone, button,
code, temperature, or message number, you can press the down arrow key to display its name, then use the up and down arrow
keys to scroll through the list of other names. This is true when entering commands and programming on the console.
To Next Page
Loading...
Need help?
General