10
onsenproducts.ca
800-996-5559
Push button located at the bottom of the water heater to the ON po-
sition.
Push the showerhead button to the ON position (this will allow for
water to circulate inside the water heater and kick start the ignition
sequence).
You will hear a series of clicks followed by the sound of the ame
igniting, similar to an outdoor grill. If the ame does not ignite after 5
seconds, shut o the water supply and close the gas valve. Go to Trou-
bleshooting on page 15 of this Operating Manual for advice.
7
8
9
IMPORTANT TO KNOW
This water heater is equipped with a wa-
ter temperature sensor that will turn o
the ame when 60 °C is reached.
This water heater is equipped with a 20
minute safety shut-o timer that will au-
tomatically turn o the ame when this
timeframe is reached. To start the water
heater again, push the showerhead but-
ton OFF and ON to reignite the ame.
To Next Page
Loading...
