onsenproducts.ca
800-996-5559
ENGLISH
USE AND OPERATION
Always check for gas leaks before using this water
heater. To do so, spray a mixed solution of water and
soap on the gas inlet connection. If bubbles start to form,
close the gas valve and seal the gas connection properly
before repeating the gas leak test.
This water heater comes with a ½” – ⅜” gas com-
pression tting already connected to the ½” gas in-
let during the assembly portion of the manufacturing
process. In the event that the gas compression tting
has been removed, make sure to connect it by apply-
ing gas tape or compound to the ½” gas inlet threads
to ensure the connection is sealed and to prevent
a gas leak. ALWAYS CHECK FOR GAS LEAKS AFTER
APPLYING GAS TAPE / COMPOUND.
Set the water regulator knob to maximum setting (turn to the left).
Set the gas regulator knob to minimum setting (turn to the left).
Ensure the showerhead button is in the OFF position.
Turn on the incoming water supply and wait for the water lines to
completely ll with water (water pressure must be between 10 – 80
PSI for ignition to occur).
Open the gas valve on the propane tank.
IMPORTANT: Check for gas leaks by spraying a mixed solution of wa-
ter and soap on the gas inlet connection. If bubbles start to form, close
the gas valve and seal the gas connection properly before repeating
the gas leak test.
1
2
3
4
5
6
DANGER
DANGER
To Next Page
Loading...
