8
onsenproducts.ca
800-996-5559
Check the gas inlet:
Check the connection of the gas regulator hose to the 3/8” gas
compression tting of the gas inlet of the water heater (the gas
regulator hose should already be connected to the gas tting). If
necessary, use a wrench to ensure a secure connection. DO NOT
OVERTIGHTEN AS THIS MAY CAUSE A CRACK IN THE GAS CONNEC-
TION AND RESULT IN A GAS LEAK.
(WARNING: Do not apply gas tape, compound or other sealant to the
threads of the 3/8” gas compression tting. The tting is ared and
does not require sealant. Applying sealant to the threads of the tting
may prevent a secure connection, resulting in a gas leak).
Install batteries / connect 12 volt ignition:
If using 2 “D” type batteries for ignition, install the batteries in the
battery box located on the bottom right of the water heater. Alter-
natively, if using 12 volt for ignition, connect the circular connector
of the included 12 volt alligator clip to the 12 volt input connection
at the bottom of the water heater. Next, connect the alligator clips
to a 12 volt battery.
When using both batteries and 12 volt for ignition, the 12 volt takes
priority.
Hang the water heater:
Hang the water heater using the bottom and top brackets onto the
included mounting screws.
Connect 20 lb propane tank:
Connect the gas regulator hose to a 20 lb propane tank. DO NOT
OPEN THE TANK’S GAS VALVE YET.
5
6
7
8
To Next Page
Loading...
