Ooni Karu 16 Gas Burner User Manual (English)

Questions and Answers:

J
joshuamckinneyJul 29, 2025
Why won't my Ooni Karu 16 Gas Burner Kitchen Appliances gas burner ignite?
- C
  Christopher WebbJul 29, 2025
  Several factors can prevent your Ooni gas burner from igniting. First, ensure proper setup by removing the chimney cap and opening the ceiling and chimney vents, and keep the door open. Check that the gas bottle is full. Inspect the hose for cracks or leaks. Avoid turning the dial too quickly. Make sure the regulator is properly fixed to the gas bottle and the hose is firmly attached to the gas burner, tightened with appropriately sized wrenches. Finally, reposition the sparker tip so it's 2-3 mm away from the front of the burner cap.
M
Michael TaylorAug 5, 2025
How to fix Ooni Karu 16 Gas Burner Kitchen Appliances oven not getting hot enough?
- B
  betty11Aug 5, 2025
  If your Ooni oven isn't reaching the desired temperature, there are several potential causes. Start by checking if the gas bottle is full. Inspect the hose for any cracks or leaks. Ensure the regulator is properly fixed to the gas bottle and the hose is firmly attached to the gas burner, tightened with appropriately sized wrenches. Also, avoid operating your gas burner and oven in extreme conditions like high wind.
J
Jean ReyesAug 13, 2025
What to do if I hear a roaring sound from my Ooni Karu 16 Gas Burner gas burner?
- C
  charrisAug 13, 2025
  If you hear a roaring sound and notice weak flames from your Ooni gas burner, it indicates the flame is burning within the venturis. Immediately switch off the gas supply and the gas burner. Wait 5 minutes, then try relighting the gas burner.
C
Christopher RamirezAug 19, 2025
What to do if my Ooni Karu 16 Gas Burner FSD is not functioning correctly?
- C
  Christopher WongAug 20, 2025
  If your Ooni's FSD (Flame Safety Device) isn't working correctly, it might be due to soot buildup on the FSD probe. To fix this, switch off the gas supply and burner, wait for the burner to cool down, then gently clean the probe and burner holes with a damp cloth. Let the burner fully dry before relighting.