Ootori RM503 - Specifications; Troubleshooting

G.W.
N.W.
SPECIFICATIONS
MEASUREMENT 40.35” ×24.21” × 18.50”
35.83" × 27.95" × 9.84"
40.16" × 20.86" × 11.02"
83.78 Lbs
32.85 Lbs
34.39 Lbs
63.93 Lbs
25.35 Lbs
29.32 Lbs
100W
120V/60HZ
RATED POWER
RATED VOLTAGE
FUNCTION
Press the button to turn on or turn o neck massage
Press the button to turn on or turn o back massage
Press the button to turn on or turn o reverse neck rollers direction
BUTTON
Kneading
Shiatsu
Kneading Mode
Shiatsu Mode
Speed
Heating
Buttock
Shoulder
Arm
Calf
Vibrating
Strength
Back Descend
Back Ascend
Press the button to turn on or turn o reverse back rollers direction
Press the button to adjust the speed of rollers in chosen area
Press the button to turn on or turn o heater
Press the button to turn on or turn o buttock compression air bags.
Press the button to turn on or turn o shoulder compression air bags.
Press the button to turn on or turn o arm compression air bags.
Press the button to turn on or turn o calf compression air bags.
Press the button to turn on or turn o calf compression seat vibrator.
Press the button to adjust the strength of airbags.
Press and keep holding the button to raise the backrest.
Press and keep holding the button to lower the backrest.
TROUBLESHOOTING
The rollers and the backrest
pad make frictional sound.
Motor sound is clearly hearable
during operation.
Loud sound is given when
tapping and kneading massage
is performed
This is the sound produced by mechanical
structure instead of failure of internal components.
This may occur during normal operation.
Massage is suddenly stopped
and the massage rollers return
to their original position.
*The preset auto-timing has been reached.
*In order to avoid the massage armchair from
causing accident due to overheat, this chair is
equipped with overheat reboot protection
equipment.
If the chair stops and fails to restart as a result of
overheat, turn o the main power switch for at least
30 minutes in order to prevent it from suddenly
starting after components are cooled down.
*The power button was pressed accidentally.
The remote controller does
not work.
*Check the power plug and ensure that it is
indeed plugged into the socket.
*Check whether the wires on the back of the
massage chair are properly connected.
*Confirm the main power switch is turned on.
The power cord and plug are
excessively hot.
Stop using immediately and contact the service
centre.
The massage stops in the
process.
Turn o the main switch on the back of the chair
and turn on 5 seconds later. If the same problem
occurs again, please turn
o the main switch, unplug the power cord and
contact the customer service.
PROBLEM SOLUTION
13 14