GrowWall
P10
User Manual
Step 9. Tidy up the Tube and Cable
1. Ensure that the tube is connected to the pump, and secured with a tightened
ring fixture. Turn clockwise to tighten.
2. Attach the other end of the tube to the water inlet. Turn clockwise to tighten.
3. Plug the plastic tie into the vertical pipe.
These parts were pre-assembled for your convenience; please check that
each item is fastened.
This will also serve as a reference guide; should you disassemble/reassemble
your unit in the future.
Note
2
1
3
1.
2.
To Next Page
Loading...