108 Vehicle care
5. Attach connector to main beam
bulb.
6. Place protective cover in position
and close.
Ellipsoidal headlights
Headlights have separate systems for
low beam (inner bulbs) and high
beam (outer bulbs).
Low beam
1. Remove protective cover by
pressing the catch and pulling the
cover downward and off.
2. Detach plug connector from bulb.
3. Disengage spring clip by
swivelling to the side.
4. Remove bulb from reflector
housing.
5. When installing the new bulb,
insert lugs in the reflector
recesses.
6. Install spring clip, plug connector
onto bulb.
7. Install protective cover.
High beam, parking lights
Have bulbs replaced by a workshop.
Front turn signal lights
1. Rotate bulb holder anti-clockwise
to disengage.
2. Push bulb into socket slightly,
rotate anti-clockwise, remove and
renew bulb.
To Next Page
Loading...
