Openpath Access Control System Installation Guide
GETTING STARTED
This Installation Guide explains how to install and configure Openpath Smart Hubs
(ACUs) and Openpath Smart Readers as part of an Openpath Access Control
system. This guide includes information about Core Series Smart Hubs and first
generation Smart Hubs. For information on the Single Door Controller, refer to the
Openpath SDC Install Guide.
ADDITIONAL RESOURCES
● Access Control Core Data Sheet
● 4-Port Board Data Sheet
● 8-Port Board Data Sheet
● 16 I/O Elevator Board Data Sheet
● 24V 4-Door Controller Data Sheet
● 12/24V 4-Door Controller Data Sheet
● 12/24V 8-Door Controller Data Sheet
● 24V Elevator Controller Data Sheet
● Smart Reader Data Sheet
● First Gen Smart Hub Data Sheet
● Openpath User Guide
● Life Safety Power FPV Installation Guide
● Life Safety Power FPO Installation Guide
● Life Safety Power B100 Installation Guide
● Life Safety Power C4 Installation Guide
PRIOR TO INSTALLATION
Prior to installing Openpath hardware, perform a customer site survey to determine
the following:
● How many entries need to be configured (e.g. doors, gates, and/or elevator
floors)
● Whether you’re using legacy wiring or new wiring
● What kind of electronic entry mechanisms, Request to Exit (REX) mechanisms,
and door contact sensors will be used and their power requirements. If your
locking hardware requires 24V, either use a Smart Hub with an included 24V
power supply (Core Series Smart Hub or OP-4ESH-24V) or use a separate 24V
supply.
○ Note: The 12V Smart Hub (OP-4ESH-12V) supports up to 2A for 12V
locking hardware.
● Whether you’re providing backup batteries for the ACUs. See SELECTING A
BACKUP BATTERY.
● Whether you’re supporting a legacy access control panel. See WIRING TO
LEGACY PANELS.
To Next Page
Loading...
