What to do if the Openpath OP-16EM Control Systems STATUS LED is solid red?
If the STATUS LED is solid red, try the following: power cycle the 4-Port/8-Port, unplug and replug the USB cable, or restart the Hardware Communicator in the Control Center.
How to solve Openpath OP-16EM ACU provisioning issues during registration?
If you're experiencing ACU provisioning issues during registration, ensure your laptop is on the same network as the ACU.
How to hard reset the Openpath OP-16EM ACU?
To hard reset the ACU: disconnect power, hold the ADMIN BUTTON for 15 seconds, reconnect the power while continuing to hold the button for another 15 seconds.
What to do if Openpath Control Systems shows 'This Site Cannot be Reached' error?
If you encounter a 'This Site Cannot be Reached' error, ping the ACU using the command line.
What to do if the Openpath OP-16EM reader isn't receiving enough voltage?
If a reader might not be receiving enough voltage or current, possibly due to a break in wiring, try connecting the reader directly to the ACU, bypassing any wire runs.
How to fix slow connections due to legacy wiring in Openpath OP-16EM Control Systems?
To address slower connections and dropped packets due to legacy wiring, switch GND and VIN with +B and -A connections on the ACU and readers.
How to install Bonjour for Openpath OP-16EM Control Systems provisioning from a laptop?
To install Bonjour software for provisioning from a laptop, download iTunes and use an archive utility to extract and install only the Bonjour MSI.
What to check if Openpath OP-16EM reader is powered but not communicating?
If the reader is connected to power but cannot communicate with the ACU, check to see if the +B [blue] and -A [violet] lines are swapped.
Details the Ethernet connection, DHCP, and firewall settings for ACU communication.
Provides step-by-step guidance on how to securely mount the Openpath Smart Hub enclosures to a wall.
Explains how to install controller boards with 24V and 12V locking hardware in enclosures.
Describes the compatible wire types and best practices for connecting Openpath Readers to ACUs.
Illustrates standard wiring diagrams for various Core Series Smart Hub models and configurations.
Covers changing I/O types, integrating legacy panels, and Wiegand devices.
Explains how to configure and use end-of-line supervision for 4-Port and 8-Port Board inputs.
Details the meaning of LEDs on ACUs for status indication.
Describes the LED indicators on Openpath Smart Readers.
Explains the various states of the Core's STATUS LED for normal operation and errors.
Guides users through soft/hard resets and the process of provisioning ACUs.
Outlines compliance with UL 294, CAN/ULC, and FCC standards for the access control system.
Provides critical safety warnings regarding servicing, power connections, and voltage modifications.
Lists the technical specifications for various Openpath hardware components, including power and FCC IDs.
General| Ingress Protection | IP65 |
|---|---|
| Operating Humidity | 0% to 95% non-condensing |
| Power Input | 12-24V DC |
| Communication | Wiegand |
| Credential Technologies | Mobile, Bluetooth |
| Output Current | 500mA |
| Operating Temperature | -40°C to 70°C |
To Next Page
