STANDARD RECOMMENDED MAINTENANCE
Perform the following recommended maintenance procedures before and after each use. If any defects are
found, the damaged components should be replaced before use.
MAINTENANCE SCHEDULE
1
Clean the helmet with a mild detergent and water.*
2
Check that the chinstrap screws are tight using a athead screwdriver.
3
Clean the Exterior Loop for dust and dirt by using air pressure.
4
Visually check the Modular Bungee Shroud and Skeleton ARCs for signs of breakage.
5
Visually check the Fitband for signs of breakage.
6
Check that the Occ-Dial Adjustment Knob works properly.
7
Check that the chinstrap does not have any damage and that the buckle latches and releases properly.
*The whole helmet can be rinsed in fresh water.
15
To Next Page
Loading...
