What to do if there is no video on the Opticis Extender display?
If there is no video on the display, wait a few seconds for the system to boot. After applying power, the Power and Wireless status LEDs should turn blue. Check all cable connections and reset the power of all TX and RX units by re-plugging the power adapter.
Why does the opticis HDWX-100-TR video freeze or collapse, showing a mosaic pattern or jitter?
The video freezing, collapsing, showing a mosaic pattern, or jittering is caused by network connectivity issues. Check your network connectivity, verify the distance between the RX and TX units, and ensure there are no metallic obstacles. Try changing the position of the antennas or switching the wireless channel.
What does "Wi-Fi time out" or "Off" message on Opticis Extender display mean?
A "Wi-Fi time out" or "Off" message on the display indicates a failure of the wireless network or the necessity of pairing between the TX and RX units. Check the environment of your room and re-plug the power adapter. Also, check the distance between the RX and TX, avoiding metallic obstacles. Check and retry connections in the GUI connectivity menu.
What to do if abnormal operation occurs in playing audio/video or USB KVM on Opticis Extender?
If abnormal operation occurs while playing audio/video or using USB KVM, reset the power of all TX and RX units by re-plugging the power adapter.
What to do if after changing source resolution, no video on opticis HDWX-100-TR Extender display?
If there is no video on the display after changing the source resolution, wait several seconds for the EDID negotiation to complete.
What to do if the video clip does not play after changing the input source on opticis HDWX-100-TR Extender?
If the video clip doesn't play after changing the input source, execute the window media player again.
Specifies the necessary hardware, like HDMI ports, for setup.
Outlines the software requirements for the HDMI graphic controller.
Details how to enter and navigate the Graphical User Interface menu.
Describes methods for connecting to available transmitters.
To Next Page
General
