Optimum CNC Controller III User Manual

Description of the connection
OPTIMUM
MASCHINEN - GERMANY
29 / 11 / 2006
Page
10
Description of the connection CNC Controller III and VI ; Version 2.0.1
© 2006
GB
7.2 Control board version 1
Fig.7-3: Control board CNC controller V1
7.2.1 Setting jumpers
When exchanging a control board, a control board has to be set as master control board, the
other control boards always as slave control boards. The setting is performed over a jumper.
The master board is always exclusively in the slot of the X or X
1
-axis and the jumper is set as
displayed below.
CAUTION!
The master board is only in the slot of the X or X
1
-axis.
Fig.7-4: Position jumper "master"
Fig.7-5: Position jumper "slave"
PotentiometerJumper Master / Slave
Jumper in position "master"
Jumper in position "slave"

Optimum CNC Controller III Specifications

General

Brand	Optimum
Model	CNC Controller III
Category	Controller
Language	English