Optimum OPTIgrind GU18 User Manual

OPTIMUM
MASCHINEN - GERMANY
Safety
Version 1.0.2 vom 2016-1-28 Page 7Original operating instructions
GU15 │GU18 │GU20 │GU20S │GU20P│GU25│GU25S│GU25P GB
Always disconnect the grinding machine from the electrical power supply when performing
cleaning or maintenance works.
WARNING!
The grinding machine may only be used with functional safety devices.
Disconnect the grinding machine immediately whenever you detect a failure in the safety
devices or when they are not mounted!
All additional devices installed by the operator must be equipped with the prescribed
safety devices.
This is your responsibility as the operating company!
 "Safety devices“ on page 8
1.5 Qualification of personnel
1.5.1 Target group
This manual is addressed to
 the operating companies,
 the operators,
 the maintenance personnel.
Therefore, the warning notes refer to both operation and maintenance of the grinding machine.
Always disconnect the grinding machine from the mains. This will prevent it from being used by
unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond operation in
standard mode must only be performed by the operator, if so indicated in these instructions and
if the operator has been expressively commissioned by the operating company.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Qualified personnel
Thanks to professional training, knowledge and experience as well as knowledge of relevant
regulations the qualified personnel is able to perform the assigned tasks and to independently
recognise and avoid any possible dangers themselves.
Instructed person
Instructed persons were instructed by the operating company regarding the assigned tasks and
any possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
 be duly qualified,
 and strictly follow these operating instructions.
In the event of improper use

Optimum OPTIgrind GU18 Specifications

General

Brand	Optimum
Model	OPTIgrind GU18
Category	Grinder
Language	English