OPTIMUM
MASCHINEN - GERMANY
Safety
Version 1.0.2 vom 2016-1-28Page 8 Original operating instructions
GU15 │GU18 │GU20 │GU20S │GU20P│GU25│GU25S│GU25PGB
there may be a risk to personnel,
there may be a risk to the grinding machine and other material values,
the correct function of the grinding machine may be affected.
1.6 Operator positions
The operator’s position is in front of the grinding machine.
1.7 Safety measures during operation
CAUTION!
Danger due to inhaling dust and mist that is hazardous to health.
Dependent on the material to be processed and the additional resources used, the
generated dust and mist may be hazardous to your health.
Make sure that any harmful dusts or mist is safely sucked off at the point of origin and
dissipated or filtered from the working area.
1.8 Safety devices
Use the grinding machine only with properly functioning safety devices.
Stop the grinding machine immediately in case of failure of a safety device or if it is not function-
ing for any reason.
This is your responsibility!
If a safety device has been activated or has failed, the grinding machine must only be used if
the cause of the fault has been eliminated,
you have verified that there is no danger to personnel or objects.
WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are
endangering yourself and other personnel working with the grinding machine. The
possible consequences are:
injuries may occur due to workpiece or parts of workpieces flying off,
contact with rotating parts,
fatal electrocution.
The grinding machine includes the following safety devices:
A spark protection on each grinding wheel.
A protective guard with shaft cover on each grinding wheel.
A support surface for the workpiece.
WARNING!
The separating protective equipment, which is made available and delivered together
with the machine, is designed to reduce the risk of workpieces or fractions of them
being expelled, but not to prevent this completely. Always work carefully and observe
the limit values of the grinding process.
1.8.1 Spark-guard and support surface
Adjust the protective equipment to the correct height before you start working. To do so, detach
the clamping screw, adjust the required height and re-tighten the clamping screw. Observe the
correct distance to the grinding wheel.
To Next Page
Loading...
Need help?
General
