Why is the display blinking on my Optimum Vario Select OptiDrill B 30VGM Drill?
If the display on your Optimum Drill is blinking, it's likely due to low voltage. Try replacing the battery to resolve this issue.
What to do if data display does not change on Optimum Drill?
If the data display on your Optimum Drill isn't changing, it might be due to interferences in the switching circuit. To resolve this, remove the battery and reinsert it after about 30 seconds.
Checks received items against the packing list.
Guidelines for safe moving and handling of the machine.
Procedures and requirements for setting up the machine.
Initial steps before operating the machine for the first time.
General safety precautions and guidelines for operation.
Identification and function of machine controls and displays.
Methods for moving the drill spindle up and down.
Procedures and safety tips for operating the drill.
Recommended settings for different materials and drill sizes.
Reference chart for spindle speeds based on drill diameter and cutting speed.
Guidance on calculating optimal drilling speeds.
Essential safety practices for maintenance tasks.
Procedures for regular inspection and upkeep of the machine.
List of lubricants, oils, and coolants.
Instructions for cleaning the machine components.
Visual breakdowns of machine components for identification.
Comprehensive list of all machine parts with item numbers.
Electrical schematics for machine connectivity and troubleshooting.
Troubleshooting steps for unusual sounds during operation.
Solutions for a burnt or damaged drill bit.
Steps to diagnose and resolve motor startup issues.
Troubleshooting causes and solutions for motor performance issues.
Legal information regarding document usage rights.
Definitions of technical terms used in the manual.
Details of the manufacturer's warranty coverage and terms.
To Next Page
General