OP175 System Installation, Operation & Maintenance 2
General Information
Safety Warning
Electrical work should be performed by a qualied
electrician in accordance with all applicable
codes and regulations.
Service Contact
For local maintenance and service information
please contact your nearest Authorized Service
Representative. Service inquiries may be directed
to technical support at:
OptiPure div. of Procam Controls, Inc.
2605 Technology Dr. Bldg. 300
Plano, TX 75074 USA
Phone #: 972.881.9797
Fax #: 972.422.6262
E-mail correspondence to:
techsupport@optipure.net
Environmental Conditions
The OP175 is certied to operate under the
following conditions:
1. Altitude up to 2000 m.
2. Ambient temperature of 40-105°F (5 - 40°C).
3. Max relative humidity 80% at 88°F (31°C).
4. Main supply voltage not to exceed +/- 10%.
5. Installation category II.
6. Pollution degree II.
7. Indoor use only, protect from elements.
Explanation of Symbols
The following symbols are used on the water
processor. The symbols and their explanation is
given below:
Earth ground:
WARNING: Hazardous Voltage:
Safety Instructions
1. Please read and follow these instructions
when connecting and using the system.
2. Never use the system if the power cord has
been damaged. Do not allow anything to rest
on the power cord, and keep the cord away
from any place where people may trip over it.
3. When disconnecting from the electric socket
hold the plug, not the cord.
4. Unplug the RP pump from the AC outlet prior
to any service.
5. Locate the RP Assembly as close as possible
to an AC outlet.
6. Securely bolt processor to wall before
operating.
7. Avoid cross-connections and install on cold
water supply only.
8. Use approved Air-Gaps when connecting to
drain lines.
9. Do not exceed system pressure rating and
use water hammer arrestors when water
hammer is evident.
10. Turn off Feed-Water supply before lter or
membrane cartridge replacement.
To Next Page
Loading...
