Need help?Do you have a question about the Optoma ES526 and is the answer not in the manual?
Display| display type | Single 0.55” DMD DLP |
|---|---|
| native resolution | SVGA (800 x 600) |
| maximum resolution | HD (1920 x 1080) |
| brightness | 2800 ANSI Lumens |
| contrast ratio | 3000:1 (Full On/Full Off) |
| displayable colors | 1.07 Billion |
Projection and Image| throw ratio | 1.95 to 2.15:1 (Distance/Width) |
|---|---|
| projection distance | 1.0 to 10 m |
| image size (diagonal) | 0.58 to 7.62 m |
| aspect ratio | 4:3 Native, 16:9 and 16:10 Compatible |
| offset | 115% |
| keystone correction | ±40° Vertical |
Power| power supply | AC Input 100-240 V, 50-60Hz, Auto-Switching |
|---|---|
| power consumption | 255 Watts (Bright), 230 Watts (STD), <1 Watt (Standby) |
| lamp life and type | 4000/3000 Hours (STD/Bright), 185W UHP |
Audio and Noise| audio | 2-Watt Speaker |
|---|---|
| noise level (STD/Bright) | 28dB/30dB |
Operating Environment| operating temperature | 5 to 40°C |
|---|---|
| max humidity | 85% |
Connectivity and Ports| i/o connectors | VGA-In, VGA-Out, S-Video, Composite Video, Stereo Audio-In, Stereo Audio-Out, RS-232 |
|---|---|
| monitor loop through | D-Sub 15-Pin VGA Output (Functional in Both Normal and Standby Modes) |
Weight and Dimensions| weight | 2.27 kg |
|---|---|
| dimensions (W x H x D) | 287 x 101 x 193 mm |
Key technical specifications and features of the projector.
Lists supported computer resolutions and refresh rates.
Lists tools and initial product overview for disassembly.
Instructions for removing Lamp Cover and Lamp Modules.
Step-by-step instructions to remove the top cover.
Steps for removing Main Board and its shielding.
Covers Speaker removal and Rod Adjustment.
Procedure to reset or update the projector's lamp usage hour.
Explains diagnostic messages indicated by LED status lights.
General troubleshooting steps for common projector issues.
Lists necessary equipment for functional testing.
Instructions on accessing service mode and performing OSD reset.
Guides on testing projector performance with PC input signals.
Procedures for measuring brightness, contrast, and uniformity.
Outlines requirements for upgrading the projector's main system firmware.
Step-by-step guide to install the DLP Composer Lite software.
Steps and requirements for upgrading the 8051 microcontroller firmware.
Explanation of Extended Display Identification Data and its purpose.
Steps for setting up the hardware and connections for EDID upgrade.
Instructions for inputting and programming EDID data.
Explains the structure and meaning of projector serial numbers.
Defines the format and components of PCBA codes.
To Next Page
