To Next Page
A
Angelica CampbellAug 10, 2025
What to do if Optoma EW605ST shows Error (Over Temp.)?
- CCarolyn GreenAug 10, 2025
If your Optoma Projector displays an 'Error (Over Temp.)' message, turn off the projector and allow it to cool down.
What to do if Optoma EW605ST shows Error (Over Temp.)?
If your Optoma Projector displays an 'Error (Over Temp.)' message, turn off the projector and allow it to cool down.
What to do if Optoma EW605ST shows Error (Fan fail)?
If your Optoma Projector displays 'Error (Fan fail)', check the fan for any blockages and make sure that it is working as it should.
How to fix Optoma Projector Error (Lamp fail)?
To fix the 'Error (Lamp fail)' on your Optoma Projector, replace the lamp.
General| Resolution | WXGA (1280x800) |
|---|---|
| Weight | 3.5 kg |
| Zoom Type | Fixed |
| Speaker | 10W |
| Projection Size | 30" to 300" |
| Input Lag | 16 ms |
| 3D Ready | Yes |
| I/O Ports | HDMI, VGA, USB |
| Keystone Correction | Vertical ±40° |
Covers repair notices and steps for front, top, rear cover, and main board removal.
Details the procedure to disassemble the photo sensor and holder.
Details the procedure to disassemble the DMD board.
Explains the procedure for adjusting the rod for image clarity.
Guides on how to re-write lamp usage hours in service mode.
Explains projector status via LED indicators.
Provides procedures for common symptoms like auto shut down and password recovery.
Procedure to reset the fan RPM after component replacement or FW update.
Guides on performing auto keystone calibration.
Details the ADC calibration procedure.
Procedure for engine adjustment when the engine is changed.
