User Controls
SETUP | Signal -RGB Source
Frequency
Change the display data frequency to match the frequency of your
computer’s graphic card. Use this function only if the image ap-
pears to icker vertically.
Phase
Synchronize the signal timing of the display with the graphic card.
If the image appears to be unstable or ickers, use this function to
correct it.
H. Position
Press the ◄ to move the image left. `
Press the ► to move the image right. `
V. Position
Press the ◄ to move the image down. `
Press the ► to move the image up. `
Automatic
Automatically selects the signal. If you use this function, the
Frequency and Phase items are grayed out, and if Signal is not
automatic, the Frequency and Phase items will appear for user to
manually tune and saved in settings after that for next time projec-
tor turns off and on again.
“Signal” is only
supported in Ana-
log VGA (RGB)
signal.
To Next Page
Loading...
Need help?
General
