English 63
ADDITIONAL INFORMATION
Projector dimensions and ceiling mount installation
1. To prevent damage to your projector, please use the Optoma ceiling mount.
2. If you wish to use a third party ceiling mount kit, please ensure the screws used to attach a mount to the
projector meet the following specications:
• Screw type: M4*10
• Minimum screw length: 10mm
371.5
112.5
120
TR0.35
M4*10
105.76
163
443.74
136
128.76
Unit: mm
Note:
Please note that damage resulting from incorrect installation will void the warranty.
Warning:
• If you buy a ceiling mount from another company, please be sure to use the correct screw size.
Screw size will vary depending on the thickness of the mounting plate.
• Be sure to keep at least 10 cm gap between the ceiling and the bottom of the projector.
• Avoid installing the projector near a heat source.
To Next Page
Loading...
